Recommended Drawing Notes
Notes: Unless otherwise specified
1) Requirements:
- 1.1 The requirement of this drawing shall take precedence over all other documents.
- 1.2 This flexible circuit shall conform to the requirements of IPC-6013 Class __
2) Material – per stack up detail:
3) Manufacturing Criteria:
- 3.1 Minimum conductor width on layer L1 shall be ________
4) Finish:
- 4.1 ***Insert Gold spec here***
- 4.2 ***Insert Plating spec here***
- 4.3 Dimensional limits, including holes sizes apply after plating.
5) Identification:
- 5.1 Silkscreen per supplied manufacturing data with non-conductive white epoxy ink.
- 5.2 Mark each circuit with supplier identification where indicated.
6) Finished circuits shall be 100% electrically tested for opens and shorts per supplied Net list.
Stamp tested circuit in area indicated per note 5.
7) Features and Dimensions not shown on this drawing are controlled by applied material's supplied manufacturing data.
8) All design changes to be approved prior to implementing.
|